Indianapolis 500 Scoring Pylon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An Indianapolis 500 Scoring Pylon, circa 2009 for a friend's Memorial Day Party
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props & Terrains
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an Indianapolis 500 Scoring Pylon, circa 2009. It was designed to scale by viewing photos of the pylon and taking measurements from them. It is designed in 2 parts; the pylon (tower) with voids for the numbers and letters, and the numbers and letters themselves without the pylon.
You will a need a printer set up for at least 2-color printing. I printed this on a BambuLabs A1mini with the AMS.
Import them at the same time and both Prusa slicer and BambuLabs slicer will place them in their proper positions. In the slicer, paint supports on the base of the pylon between the legs, choose which color you would like each part to be, then slice and print.
It says it takes 24 hours to print with 0.2mm Layer Height, 2 Wall Loops, and 10% Grid sparse in-fill. I used the textured PEI print sheet. I did several partial height test prints, and 1 full height test. I never had a print failure.