Panini Sticker Drawer System

Panini Sticker Drawer System -- Modular Storage for Collectors

The FIFA World Cup 2026 is over, but some of us are still hunting for the last stickers.

Trading goes a lot smoother when your collection is organized, so I designed this fully modular drawer system for Panini stickers.

How it works

Its a mix-and-match system of housings and drawers in different sizes. The number in each Filename tells you its slot count:

• Housing_Panini_X: X tells you how many slots the housing holds.

• Drawer_Panini_Y:    Y tells you how many slots the drawer uses.

As long as your drawer numbers add up to your housing number it will fit perfectly. You can use your preferred drawer size and can make it fit your Panini Collection size.

While closing the drawers they lock into place with a slight push. To unlock them, you have to pull gently. So you can carry them around for Trading without losing anything.

Drawer capacities (estimated)

• Drawer_Panini_1: 20 Stickers

• Drawer_Panini_2: 55 Stickers

• Drawer_Panini_3: 90 Stickers

• Drawer_Panini_4: 125 Stickers

• Drawer_Panini_5: 150 Stickers

Tips

I like Drawers 1 and 2 most. I think they hold a good amount of stickers and allow for easy handling. But bigger sizes are also avaiable.

If you use Drawer 1 i recommend inserting half of them upside-down alternating. So the handle is on different sides and easier to grab.

In the Gallery Picture you can see drawer sizes 1,2 and 3 and Housing 6 and 8.

Printing

I printed everything with the following configuaration:

• Material: PLA

• Layer Height: 0,2mm

• Nozzle: 0,4mm

• Support: No

• Infill: 15%

• perimeters: 2

• Orienation: standing (see attached pictures)

Happy collecting, trading, and printing!