Spider and spiderweb Halloween decor

Halloween is coming, so it's time to decorate your apartment with spooky props.
I invite you to print out the spider and its web.
We use two colors: black PLA and red PLA (could be red silk too). 
Also Bambu support filament (or PETG) for suports to print additional spiders from bonus plate.

Spider and his web.
0.2mm is the height of the first layer.
I set the last layers to 0.08mm to print the spider in better quality.
Only the black PLA filament will be needed at this point.

Red back
The red (PLA) element for the spider will print with heights of 
0.2mm for the first layer and 
0.08mm for each subsequent layer.

After printing, we connected the red element to the spider. I didn't use glue.

I used thin double-sided tape to attach the spiderweb to the door frame.
Short pieces, only 2mm thick, were perfectly sufficient, as you can see in the photos.

PLATE 3
If you'd like to print just the spiders, I've included an additional plate with spiders that you can, for example, put on your fridge. An 8x1.5mm magnet hole is provided.

The support option should be enabled. 
I used Bambu support filament for the supports, but you can also use PETG as the support filament.

Remember to print the appropriate amount of red elements for the additional spiders.

You gently press the magnets into place. I didn't use glue, but you can use it if you want.