1 / 2
Bb Tinwhistle (13mm bore, printed fipple mouthpiece + body) — zdjęcie 1
1 / 2

Bb Tinwhistle (13mm bore, printed fipple mouthpiece + body)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A fully 3D-printed tinwhistle in Bb, built as a fipple (ducted) whistle with a printed windway and labium.

Ocena
0 / 5
Polubienia
2
Pobrania
7
Wydruki
0
Wyświetlenia
61
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

# Bb Tinwhistle (13mm bore, printed fipple mouthpiece + body)

A fully 3D-printed tinwhistle in Bb, built as a fipple (ducted) whistle

with a printed windway and labium -- the standard tinwhistle mechanism,

reliable and easy to voice, no embouchure skill required to get a

clean sound.

## What this is

- Bore: 13mm ID, 2mm wall

- Mechanism: fipple/duct whistle -- internal windway shapes and

aims the air jet across a labium edge, same principle as a

traditional tinwhistle or recorder, rather than a transverse

embouchure you blow across yourself.

- Construction: two-piece design (mouthpiece + body) joined with a

tenon/socket fit, sized to print within a standard bed without

needing supports through the internal windway geometry.

- Tuned and voiced by hand across multiple print iterations --

windway clearance, labium angle/distance, and wall thickness were

all adjusted through direct testing rather than calculated once and

left alone.

## Status

Working, printed, and playable. This is one of several whistles built

in the same family of iteration (different keys/sizes share the same

core mouthpiece approach) -- this listing is specifically the Bb.

## Notes for anyone printing this

- Print orientation matters for the windway/labium region -- get this

wrong and you'll fight sagging or rough internal surfaces that kill

the voicing. I recommend printing the mouthpiece at a 45 degree

angle, but your experience may vary.

- Any tuning adjustments after printing (undercutting the labium,

opening tone holes slightly) are normal for a first print and don't

indicate a design fault.

## Files

- Ready-to-slice STLs

## License

CC BY-NC-SA -- attribution required, non-commercial use only,

derivatives must stay open under the same terms.

## Credits

Design, testing, and all the physical building/iteration by me.

OpenSCAD source developed with the help of Claude (Anthropic).

The "low tech" tinwhistle guide: https://www.guidogonzato.it/whistle/

Tagi