INDX Rear Filament Sensor Mount Core One
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket to mount the INDX filament runout sensors on the rear of the printer.
- Ocena
- 4,833 / 5
- Polubienia
- 45
- Pobrania
- 113
- Wydruki
- 7
- Wyświetlenia
- 1677
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print the bracket PETG or stronger, PLA might be too brittle and will be exposed to the heat from the printer case.
I recommend at least 4 walls, 4 top and 4 bottom, 20% Gyroid infill to endure strength around the screw holes.
STEP 1: Start by removing the four plastic rivets circled on the rear.
STEP 2: Insert the self tapping torx screw, that came with the sensor, through the mount.
STEP 3: Using the torx screw, attach the filament sensor to the mount. The sensor will fit snugly into the notch on the mount and the screw holes will be aligned.
STEP 4: Insert the plastic rivets through the top and bottom hole on the mount. TIP:Remove the centre piece from the rivet to make it easier to install.
STEP 5: Press the mount and the plastic rivets into the holes in the printer frame. Reinsert the centre piece into the plastic rived. This might be a little hard to push in so be careful not to bend the rivet out of shape. It will pop in securely and hold the mount to the printer frame.
STEP 6: If you have an 8 tool printer, repeat the process for the other side.
