1 / 3
Air flow redirector for Shark NeverChange air purifier — zdjęcie 1
1 / 3

Air flow redirector for Shark NeverChange air purifier

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The air purifier cycles air straight up, this will redirect the flow horizontally. For Shark NeverChange air purifier.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
36
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The air purifier propels air straight up, but I needed to redirect the flow horizontally, so I made this 3 part print to redirect the air.

Printed at .2 layer height with a very low infil, slip fit on the top of the air purifier.

Print the base ring first to confirm that it fits, there is a relief for a protrusion on the front of the fan.  Model has 2mm locating holes that can be used for aligning parts for gluing, a small drill bit will open it up if you wish to use short sections of filament for the pins.

Upper halves were printed with the joining sides on the build plate, and organic supports.

This model fits on a Core One L, make sure you have sufficient build volume, its a largish print.