Midea PortaSplit Condensate Cleaning Tablet Holder

Earlier manuals recommend cleaning the condensate tray with AC cleaning tabs.

However the PortaSplit doesn't really come with an ideal location to put these tabs - one might be able to squeeze them in behind the plastic to the left and right of the slot where you can reach the condensate tray from, but I was worried that vibrations might carry the tab out of there.

Putting the tabs directly into the reservoir makes them dissolve far too quickly.

The purpose of this model is to try to keep the tab above the standing water level, so the tab is never fully submerged. Instead the condensate can drip onto the tablet, and (ideally) drain from the holder immediately.

I generated this model for the StayClean Cleaning Tablets, and it will likely not fit tabs that are larger.

Ideally print with a water resistant filament like ASA or PETG. If you use PLA, it might degrade quicker, so a reprint every year might be needed.

Probably good to inspect it for bacterial growth, and ideally clean monthly. 

Use at your own risk, I take no warranty whatsoever that this works as intended. It might break your device, kill you, or summon Cthulhu.

I also haven't properly tested this model really myself yet since there was currently no need for the AC at this time. I might update this post when I do test it, but I just wanted to get it uploaded in case people might want to try it and so I don't forget.