Screw-Adjustable Tension Hook for Grommet Projector Screens
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall hook with M3 lead-screw tension adjustment for grommet-hung projector screens. Prints support-free. ±6.5mm travel.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A two-piece wall hook for foldable projector screens that hang from grommets (designed around the Mdbebbron 120" 16:9, fits any screen with ~10mm grommets). Instead of repositioning hooks to chase wrinkles, each hook has a built-in lead screw: turn the M3 socket screw at the outer edge and the hook slides ±6.5mm (½" total travel) to fine-tune fabric tension. Clockwise = more tension, ~0.5mm per turn. Screen tension keeps the screw head seated, so it holds position indefinitely with no clamp.
The slider rides in a dovetail-lipped channel with 0.4mm engagement clearance and can't lift or rotate. The screw head faces the outside edge of the screen for easy hex-key access after the screen is hung.
Hardware per hook
1× M3×35 socket head cap screw (M3×40 also works)
1× M3 nut
2× #8 wood/drywall screws (flat head) for wall mounting
Printing
Both parts print flat-side down, zero supports (45° lips, teardrop bore, recessed counterbores)
PLA is fine indoors; PETG for garage/outdoor
4 perimeters recommended; infill 25%+
Enable elephant's foot compensation (~0.15mm) if your first layers run wide — the channel is a sliding fit
Assembly
Mount the base with two #8 screws, lug end pointing away from the screen center
Slide the slider into the channel from the inboard end
Drop the M3 nut into the pocket behind the hook post
Push the screw through the lug from the outside and thread it into the nut
Hang the grommet on the post, then adjust tension with a hex key
Hooks in studs need no anchors; for drywall-only locations, Wall Dog–style self-tapping screws work without anchors at these loads (a few lbs per hook, mostly shear).
Tip: you may not need adjustable hooks at every grommet — tensioners at the corners and top-center with simple fixed hooks elsewhere works well.
