INBXX angled PTFE passthrough, PTFE holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hardmounted small plug with PTFE passtrhough and custom PTFE holder for routing tubes around the back of the printer
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 108
- Wydruki
- 5
- Wyświetlenia
- 659
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Both of these should lineup with A2 version of INBXX.
Chapter names contains links to the onshape project files.
Small angled PTFE passthrough:
Passthrough is angled 25° to shorten the bend radius and hardmounted to stop it poping out of the hole.
BoM:
2x M3 hex nut (or Nyloc nut)
2x at least M3x8
Assembly:
Pull M3 nuts from behind of inner part (the one with hex cutout)
To route the tubes the "right" way line the passthrough with either locator pin or PTFE holes (on the outer side) at the top
Secure with M3 screw
PTFE holder:
BoM:
4x M3 hex nut (or Nylock nut)
4x M3x10
Assembly:
Pull M3 nuts from behind into holder
Secure holder with 2x M3 screws and nuts to the back panel
Route PTFE tubes and secure the cover with 2x M3 screws