Flashforge Creator 5 Waste Bin with Wiper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This poop bin uses an A1 Mini wiper replacement from Amazon (link in Description) among other changes.
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 252
- Wydruki
- 2
- Wyświetlenia
- 1208
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
*Update* - Revision 2 of the Creator 5 Waste Bin with wiper.
Changes:
Adjusted the height and location of the wiper mount pad to optimize where the Waste Bin sits
Increased the incline of the ramp to enhance purge waste clearing
It was pointed out, and confirmed after testing, the original model will be bumped into during bed leveling. After much testing of different configurations, I've determined it is not really possible to have the wiper low enough not to interfere with the feeder motor housing during leveling and still be able to wipe the nozzle end after purging. Therefore, I recommend monitoring the printer while bed leveling is in the final stages near the waste ramp and remove temporarily if desired. In my testing Revision 2 will be slightly nudged downward without being knocked off, but it is possible which could cause issues when a print completes.
This waste bin builds on the model from Justin Hassleshoot. I have remodeled it from scratch with the following changes:
Added a wiper (B.L. - A1 Mini replacement from Amazon https://a.co/d/07gVGjZI)
Increased the height slightly to accommodate the added wiper.
Increased the incline of the ramp for better poop clearing, this in turn made the catch basin larger.
Decreased the number of magnets from six to five, I felt five was enough.
Added some fillets and chamfers in some locations to help keep waste from side walls and make printing smoother.
I have tested the new design and wiper on a few prints and filament reloads. It seems to do a decent job of preventing stringing from the purge location onto the bed. It only gets one pass across the wiper as it returns to the dock, and does not use the wiping action like it did on the stock front wiper prior to the firmware update.
**DO NOT mistake the A1 Mini wiper with the regular A1 wiper which is shorter. The "sticky back" on the Amazon replacements are a complete joke and I ended up just using CA glue to attach the wiper.
It's a good idea to line the ramp and catch basin with foil tape to prevent the purge from sticking.
Update: I forgot to include, I printed this model with 0.2 L/H, 15% I/F, no supports. The magnets are 6x3mm.