1 / 2
Low D Tinwhistle (22mm bore, printed fipple mouthpiece + body) — zdjęcie 1
1 / 2

Low D Tinwhistle (22mm bore, printed fipple mouthpiece + body)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A fully 3D-printed low D tinwhistle, built as a fipple (ducted) whistle with a printed windway and labium.

Ocena
0 / 5
Polubienia
0
Pobrania
15
Wydruki
0
Wyświetlenia
89
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

# Low D Tinwhistle (22mm bore, printed fipple mouthpiece + body)

A fully 3D-printed low D tinwhistle, built as a fipple (ducted)

whistle with a printed windway and labium. This is the reference size

for the whole whistle family -- the bore, tenon dimensions, and

windway/labium numbers here were the ones with real print-and-test

history that the other sizes (G Alto, High D) were scaled from.

## What this is

- Bore: 22mm ID

- Mechanism: fipple/duct whistle -- internal windway shapes and

aims the air jet across a labium edge, same principle as a

traditional tinwhistle or recorder. Low whistles need more breath

and a slower air stream than a standard D to speak cleanly.

- Construction: Five-piece design (round wing-style mouthpiece +

body) joined with a tenon/socket fit.

- Requires a wider finger spread than the smaller whistles in this

family (standard D, G alto) -- worth knowing before printing if hand

size/reach is a factor.  If you have issues with your fingers not being 

able to reach the bottom note, try my key extender from here:

https://www.printables.com/model/1788912-low-d-whistle-pin-hinge-key-with-rubber-band-retur

Status

Printed as five pieces: mouthpiece, a short tenon/coupler section, and three tone-hole body sections — assembles into the full-length whistle with clean tenon joints between pieces (see photos). Fully tested, works well.

## Notes for anyone printing this

- Print orientation matters for the windway/labium region -- get this

wrong and you'll fight sagging or rough internal surfaces that kill

the voicing. Personally I found a 45 degree angle best for printing 

the mouthpiece.

- Any tuning adjustments after printing (undercutting the labium,

opening tone holes slightly) are normal for a first print and don't

indicate a design fault.

- One of the tenon joints was snug enough during testing that a wrap

of tape helped hold it tightly seated -- not a permanent fix, just

worth knowing your first print might want a similar temporary aid

(or a slightly loosened tenon clearance) until you're happy with

the fit.

## Files

- Ready-to-slice STLs

## License

CC BY-NC-SA -- attribution required, non-commercial use only,

derivatives must stay open under the same terms.

## Credits

Design, testing, and all the physical building/iteration by me.

OpenSCAD source developed with the help of Claude (Anthropic).

The "low tech" tinwhistle guide: https://www.guidogonzato.it/whistle/