1 / 6
Trojan Horse Earring — Wooden Horse of Troy — zdjęcie 1
1 / 6

Trojan Horse Earring — Wooden Horse of Troy

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The wooden horse of Troy as a wearable charm — a wheeled-plank Trojan Horse pendant.

Ocena
5 / 5
Polubienia
0
Pobrania
4
Wydruki
1
Wyświetlenia
13
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The Wooden Horse of Troy, as a charm you can wear. A side-profile Trojan Horse standing on its wheeled plank cart — the two hub-holed wheels and the plank base are what read "Trojan Horse" instead of just "a horse". A jump-ring bail sits over the centre of mass so the charm hangs level.

Two flavours are in the download — pick either or print both:

1. Flat silhouette (trojan_horse_earring.stl) — a 2 mm linear_extrude profile with engraved wooden plank seams and a little belly hatch-door (the door the soldiers climbed out of). Prints flat on the bed, zero overhangs, no supports.

flat pair

2. In-the-round 3D horse (trojan_horse_earring_meshy.stl) — a fuller rope-lashed wooden horse on a roller cart, with a fused jump-ring bail in the withers so it hangs facing forward. Prints back-down, supportless.

3D variant

Assembly: thread a jump ring through the bail hole and hang from an ear wire or a necklace chain. No supports, no glue.

Print notes

  • Any filament; PLA is fine. ~34 × 43 mm at scale_f = 1.0 (resize in the .scad).

  • Flat: prints face-up, engraved side up.

  • 3D: prints flat-back-down, dome up.

Source .scad is attached — tweak scale_f to resize, toggle wheels / planks.

Tagi