Easy&Fast 10x15 Photo frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 10x15 photo frame for quick printing without supports, offering a choice of two frame thicknesses in a single model.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
The photo frame is designed for inserting a photograph during printing. It will therefore not be possible to remove the photograph. The photograph will be permanently printed in place.
In the slicer, you must set a pause just before the filament ‘covers’ the edges of the photograph.
For example, with a layer height of 0.2 mm, the pause occurs in layer 13.

The photo frame is double-sided. You can use either the side with the thick frame or the side with the thin frame.
To be on the safe side, I recommend placing a few drops of glue on the photograph when positioning it and attaching it with the glue to the finished surface of the frame. This will ensure that the photograph does not warp or get blown away during printing.
The printing time for one frame is approximately 1 hour (without a pause).
The internal dimensions of the model for the photo area are 103 mm x 153 mm
Recomended settings:
Layer 0,2mm
Linear infill 15%
3 layers of shell on top
3 layers of shell at the bottom
Pause in layer 13 (with 0,2mm)
Tips:
You can use a textured printing mat with a pattern for a more interesting result.
When printing with multiple materials, you can draw or write decorative elements on the visible part of the photo frame in the slicer.
CZ:
Fotorámeček je určen pro vložení fotografie v průběhu tisku. Fotografii nebude tedy možné vytáhnout. Fotografie bude zatisknuta na pozici na pevno.
Ve sliceru je nutné nastavit pauzu v moment než dojde na "pokrytí" okrajů fotografie filamantem.
Například při 0,2mm vrstvení je pauza ve vrstvě 13.
Fotorámeček je oboustranný. Můžete použít stranu se tlustým rámem nebo stranu s tenkým rámem.
Pro jistotu doporučuji při pokládání foptografie dát na fotografii pár kapek lepidla a přiložit lepidlem na již hotový povrch rámečku. Zajistí se tak aby nedošlo v průběhu tisku ke zkroucení nebo odfouknutí fotografie.
Doba trvání tisku jednoho rámečku je přibližně 1 hodina (bez pauzy).
Tipy:
Můžete použít texturovanou tiskovou podložku se vzorem pro zajímavější výsledek.
V případě tisku multimateriálem je možné ve sliceru namalovat/napsat ozdoby na viditelnou část fotorámečku.