Mushie XR down unda sensor ssv3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mushie front footpad for using the SSv4 sensor on the bottom of the pad, must use a aluminium plat under the pad as well
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mushie footpad for XR with the sensor under the pad (down unda) so its easy to swap out grip tape
To use this pad as intended you will also need a strong aluminium plate that goes under the pad for support. When printed place the SS V3/4 sensor under the pad and seal it all in with a vinyl sheet or something similar on the bottom of the pad. This is what i have done and it is holding up well. There are many ways to do it though, so as long as you can seal the sensor on the bottom of the pad for water and dirt it will work, then put the entire pad/sensor combo on a aluminium plate 2mm min and get your stoke on.
I have included an infill model that may be useful for when printing, please use as you see fit.
Print in TPU with 7ish walls for strength and as low as percent infill as you can get away with.
TPU or experimentally with PEBA