SV08 Jabberwocky Stock Mount Adapter remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Changed design from the original to sit on the SV08 carriage and to make a rigid connection to Jabberwocky tool head.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I had two problems with the OG adapter plate on my machine: the adapter rests on the belt bolts and not the carriage plate and although the dove tail works really well the assembly pivots by the cartographer bolts in X and Y.
In this remix the “stock mount adapter” is now 1.4mm thicker with a chamfered base. This makes the adapter flush to the carrier and now all three bolts secure it in compression without bending the adapter.
This remix uses two m3 self tapping holes and requires 2x 40mm M3 bolts and 8 M3 washers. These bolts replace the 35mm bolts of the standard design that hold the Jabberwocky to the mounting plate.
Fit the 40mm bolts each with 4 washers and screw them in until the ends are flush with the m3 inserts on the back of the mounting plate. Mount the Jabberwocky on the remixed adapter and gently screw the bolts a few turns until they bite the adapter plate. If your dimensions are good then the bolts will cut into the 3mm holes. You should remove the toolhead to check the alignment before fully tightening.
The result on my machine is a much more stable fitting.
I only have one machine to work on (my SV08) so I have to keep dismantling it to check my dimensions. Only when I know all parts will fit reliably will I swap over to the Jabberwocky, then I can start the configuration fun!
Currently my SV08 is on mainline Klipper and Klipper eddy support (not Eddy-NG) with the Sovol Eddy probe - it has become very reliable and accurate.
If you need to remove the Jabberwocky from the carriage don't forget to loosed the two front bolts ;)
This design works best if you have a calibrated printer to start with.
Thanks again to Valerie for showing the way.
