1 / 1
G Alto Tinwhistle (20mm bore, printed fipple mouthpiece + body) — zdjęcie 1

G Alto Tinwhistle (20mm bore, printed fipple mouthpiece + body)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A fully 3D-printed alto tinwhistle in G, built as a fipple (ducted) whistle with a printed windway and labium.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
31
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

# G Alto Tinwhistle (20mm bore, printed fipple mouthpiece + body)

A fully 3D-printed alto tinwhistle in G, built as a fipple (ducted)

whistle with a printed windway and labium -- same mechanism as the Bb

tinwhistle in this family, scaled up to alto G's larger bore. Sits

between the brightness of a standard D and the depth of a low whistle

-- a mellower, rounder tone without the finger stretch a full low D

demands.

## What this is

- Bore: 20mm ID

- Mechanism: fipple/duct whistle -- internal windway shapes and

aims the air jet across a labium edge, same principle as a

traditional tinwhistle or recorder.

Construction: three-piece design — mouthpiece, a tone-holed middle section, and a foot section — joined with two tenon/socket fits, both sized specifically for this build rather than scaled down from another size's joint dimensions.

Status

Printed as three pieces (mouthpiece, tone-hole body, foot), with the tenon fit adjusted since the first print. The middle-section-to-foot joint is now a perfect fit after tightening. The mouthpiece-to-middle-section joint improved but is still a touch loose — if you print this, you may still want a small tape shim there, even with the current tenon numbers. Overall satisfied with the result, and this particular whistle has now been superglued together as a finished instrument (no longer disassembles for further testing).

Notes for anyone printing this

  • Print orientation matters for the windway/labium region — get this wrong and you'll fight sagging or rough internal surfaces that kill the voicing.

  • The mouthpiece-to-middle-section joint may still need a small tape shim even with the current tenon numbers (see Status above) — the middle-to-foot joint should fit cleanly as-is.

  • Any tuning adjustments after printing (undercutting the labium, opening tone holes slightly) are normal for a first print and don't indicate a design fault.

## Files

- Ready-to-slice STLs

## License

CC BY-NC-SA -- attribution required, non-commercial use only,

derivatives must stay open under the same terms.

## Credits

Design, testing, and all the physical building/iteration by me.

OpenSCAD source developed with the help of Claude (Anthropic).

The "low tech" tinwhistle guide: https://www.guidogonzato.it/whistle/