Tarp clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mechanical tarp clip without need for any extra parts. Uses only 2.38g / 0.93m of filament!
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 32
- Wydruki
- 1
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Fully printable, mechanical tarp clip.
🖨 Share your makes! 🖨
I'd love to see how this model turns out for you.
Options
I made this one with horizontal hole to fit my purpose. Let me know if you'd use a more common vertical one.
How to print
I went through a lot of trial and error to figure out how to print it small without snapping under tension.
Material
I recommend printing in ASA for strength and UV resistance. Other materials should work too though.
If printing with ASA, I also recommend smooth PEI plate with glue stick. Even though the parts are small, they have enough area to not separate from the plate during printing.
Supports
Orientation of the main piece matters a lot and unfortunately it requires supports, which are not too difficult to remove (I already printed 25 of these). The supports are generated on the object itself as well, not only on build plate. See the image below for their location if not using the attached project (viewed from the bottom):
Layers and perimeters
Nozzle: 0.4 mm
Layer height - other: 0.2, first: 0.2
Perimeters: 3
Solid layers - Top: 5, Bottom: 5
Extra perimeter if needed
Detect bridging perimeters: Yes
Single perimeter on top surfaces: All top surfaces
Only one perimeter on first layers: Yes
Infill
Fill density: 0%
Top/bottom fill pattern: Monotonic lines
Skirt and brim
No brim
Support material: Everywhere
Generate support material: Yes
Auto generated support: Yes
Overhang threshold: 45
First layer density: 80
First layer expansion: 2
Style: Snug
Top contact Z distance: 0.1
Pattern: Rectilinear
Top interface layers: 1
Pattern spacing: 2.5
Top interface layers: 1
Support on build plate only: No
For Bottom:
Auto generated support: No (paint them using smart fill)
Assembly
You'll need needle-nose pliers/utility knife and tweezers to remove the supports.
The parts slot into each other as follows:
Editing
Remixes are welcome. The original model can be copied from OnShape.
Changelog
2026-07-26 - 1.0.0
Initial release