Short "Osprey" Airsoft Suppressor - No Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
gkatev's short Osprey that needs less support.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This version cuts the entire back of the can off so it can be printed separately, much like the front. Added an alignment groove to the top of the can so both pieces can be printed upright.
Swapped threads to the 14mm CCW from AViera, but kept the dumber sand/cut till fit from gkatev. In fact, it's longer. no more spacer, this one's probably too long already. I modeled this one to match my platform: "Elite Force x Walther PDP Compact"
Front was unchanged from gkatev's version, but all tolerances on the back were tightened up quite a bit. Brim is ~0.26 on that new back groove, and threads were outright shrunk as it felt too loose before.