TECE Flush Plate Push Rod M8
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement M8 threaded push rod for TECE flush plates, designed for horizontal printing without supports.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
Summary
This is a replacement actuator/push rod for TECE flush plate mechanisms that use an M8 x 1.25 thread. The part was printed in PETG, installed in a real mechanism and tested during normal flushing.
The threaded section has one intentionally flattened side. Place this flat directly on the build plate. This orientation provides good bed contact, avoids supports and gives the long rod better bending strength than vertical printing.
Dimensions
- Thread: M8 x 1.25
- Threaded length: 100 mm
- Contact pad: 8 x 8 x 15 mm
- Overall length: 115 mm
- Printed thread allowance: -0.10 mm radially (7.80 mm major diameter)
The STL contains one push rod. Many dual-flush plates require two, so duplicate the object in your slicer when needed.