1 / 5
Dachshund Earring — 3D Wiener Dog Charm — zdjęcie 1
1 / 5

Dachshund Earring — 3D Wiener Dog Charm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A genuinely 3D little sausage dog charm — a plump barrel body, long snout, two floppy ears

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
42
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

A genuinely 3D little wiener dog you can wear. Not a flat relief — this is a volumetric sausage dog: a plump ellipsoid barrel body, a raised head with a long blunt snout, two floppy ears, four stubby legs and a jaunty up-and-back curl of a tail. It's rounded on ALL sides, so it reads as a dachshund from every angle.

dachshund charm

A jump-ring bail rises off the back ridge (bridging ear-to-ear) so the charm hangs level from an ear wire or a chain.

In the download:

  • dachshund_earring.stl — one dog + bail (single filament)

  • dachshund_earring_pair.stl — two dogs, mirrored left- and right-facing, laid out on one plate for a matched pair in a single print

  • dachshund_earring.scad — fully parametric source

Print notes

  • Prints belly/feet-DOWN, flat on the bed, NO supports — everything rounds upward from a flat first layer, zero overhangs underneath.

  • ~28 mm nose-to-tail at the default scale_f = 0.72 (bump scale_f to resize).

  • Any filament; PLA is fine. 0.2 mm layers, 2–3 walls.

  • Thread a jump ring through the bail hole and hang from an ear hook — print twice (or use the pair STL) for a matching set.

Tweak in the .scad: scale_f (size), width (plumpness), bail_od / bail_id (jump-ring fit), bail_axis ("across" ear-to-ear or "along" nose-to-tail), eyes (eye dimples on/off).

Tagi