Odyssey Pool Noodle Sword Hilts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to print pool noodle "sword" hilts.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 378
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
Odyssey Pool Noodle Sword Hilts
Turn any pool noodle into a sword with these Greek mythology–inspired hilts — insert a foam pool noodle as the "blade" and you've got a safe, soft sword ready for backyard duels. Choose your character: the snarling one-eyed Cyclops, or the helmeted Greek Warrior. Each comes in two sizes to match your noodle — measure yours before printing, since pool noodles vary more than you'd expect.
Big — fits noodles around 72mm diameter
Small — fits noodles around 53mm diameter
Print settings:
Print with the handle facing up. Supports are optional — without them you may get a little sagging on the overhang where the face meets the collar, but it's minor and gets hidden once the pool noodle is inserted, so it's not worth stressing over. 10–15% infill is plenty; this isn't a load-bearing part, and lighter infill keeps it buoyant. PLA is fine if it's just for display or occasional splashes, but if it's going to live poolside and take real sun, heat, and chlorine exposure, PETG or ASA will hold up a lot better over a full summer.
Note: I did use AI to help render some of the images you see in the listing, but the design and build was done by me in Fusion.