Align Trex 500L parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom parts made for Align Trex-500L
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Had issues with vertical stabilizer mount that came from factory which was not so good fitting into the designated parts and was not as reliable as it should have been, made one with higher central part, that eliminates tail rotor movement around the tail boom.
Antenna and Antenna to tail boom mount was designed for receivers-flybarless units that are mounted on the highest gyro mount-base. To assemble it you will need to have 2x M3x6mm screws and 2x M3 nuts. You press fit nuts into the designated places Antenna to tail boom mount(shown on the photo). Then place the M3 screws into the Antenna mount. Align the antenna mount with screws to the top 2 holes on the Antenna to tail boom mount, drive screws in and thats it.
Additionally for antennas use the heat shrink tubing to fixate them to the Antenna mount
P.S. If you printed it and wonder why there is a wobble, I know that the Antenna to tail boom mount is little loose, I did it on purpose not to shove it on the tube by force, that thing is not to worry about at all🙂🙂