SNAPMAKER U1 improved Motherboard 24V fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case to cool down the stepper motor driver on the Mother Board. Design remixed by using a 24VDC fan, 80*80*15mm.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 69
- Wydruki
- 1
- Wyświetlenia
- 935
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hello,
I decided to remix the linked model because I didn't like the 24v to 12v converter as the system is powered in 24V and the mainboard has two V- and two V+ terminals.
So I remixed the 3D design to fit a 80*80*15mm fan (found on Amazon) and of course powered in 24VDC. I also increased the gaps for the wires to stay loose. And finally, I reduced the depth of the 3D model. I also used the Noctua vibration mounts (ref NA-SAV4) to hold the fan on the case.
I printed it with an ESUN PLA+ BoneWhite filament.
I will try to explain the differents thoughts I add during the process.
Below is the PSU where I plugged the FAN.
Green square : Line, Neutral and Ground from your mains.
Blue square : don't touch unless you want to correct the voltage of the V+ if it's too high/below the desired voltage.
Red square : the V- and V+ terminals you can use from any purpose. It is 24V powered. It's here where I plugged the wires of the fan.

Here is the PSU screw that I removed on the first picture.

Don't forget to clear the wires of the fan in order to plug them under the voltage screw shown above.

I put the fan in the MB case like below and I roll the white wire (useless here because the PWM feature is not used). And don't forget to cut the vibration mounts edges.

Then, you need to extend to length of the wire to pass them by the bottom of the printer, then the PSU case to have a neat assembly.
Here is the final stuff, in the red circle is the 3mm drilled hole. You can also see that I used thermoformable sleeve in order to protect the wires :

I "plugged" the wired BELOW the screws, RED=V+ , BLACK=V- .

And the final assembly. The blue line is where the wires are passing.

Don't forget that every fan have a direction, in my design I decided to extract the air towards the holes of the right panel. The problem I see now is that there are not so much holes in the panels, so may be in the future, I will remove the original panel and change it with a more customizable panel :)

The results? I live a warm region (like Florida) and I reached 95°C (203°F) on the stepper motor controler. After the upgrade, I decreased the temp. by 30°C (86°F) minimum and that's in summer, with the panel (the extraction flow is not optimal) and inside a huge "chamber" I made by myself. In winter it's gonna be even more better :)

A huge thanks to El Flecko @ElFlecko_423084 and Chance Stad @ChanceStad_3622986. Their work helped me so much.