1 / 3
Zyxel Wireless Access Point Stand — zdjęcie 1
1 / 3

Zyxel Wireless Access Point Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A stand for some Zyxel wireless access points to mount it vertically.

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
35
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A stand for Zyxel AX1800 and AX3000 wireless access points. It should also fit any other Zyxel access points that look the same. A support is needed for the hole for the latch. In my slicer I chose the "snug" support option so that the support just filled the hole and didn't extend down to the base of the model.

You can print this in PLA but I recommend something a bit more heat resistant like PETG as the access points do run quite warm and I noticed my PLA print bowing slightly after a few days.

Update: Version 2 of the model has a shorter base which looks a lot neater.