Galactic Unicorn (Pico W Aboard) - Screen mount, Pivot angle, Inserted Hex Nut Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Galactic Unicorn Screen Mount, modified to use a hex nut instead of a heat insert
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Same as @PsychoShaft_33891's model, except that it uses a hex nut instead of a heat insert. This should be easier to install, and should be stronger than a heat insert.
The stand model is identical to the original, and only provided here for convenience.
Additional Hardware
Assumes an M3 hex nut with a 5.5mm socket size. You will still need a 25mm M3 Screw to go through the stand and the M3 hex nut. A few tolerances are provided.
You will also still need M2 self-tapping screws to secure the screen to the plastic inside the case.
Printing Suggestions
I suggest orienting the frame front-face-down when printing to avoid overhangs.
Like the original model, it shouldn't need supports, though you can choose to paint-on supports to the hole on the side if you're worried about the bridging.
The original model is designed for a 350mm print bed. If the print is too large for your bed, you can cut the model in half with your slicer and add dowels. If you're using PLA, super glue (cyanoacrylate) works well.
Tolerances
If you're unsure, start with 0.1mm. You'll want a tight fit. If it's too tight, use 0.2mm. If it's too loose, use 0mm. You can cut the model in your slicer and just print the bottom of the frame if you want to experiment.
If none if these work for you, the OnShape model is here: https://cad.onshape.com/documents/f9582a1d9d2f02f62268157f/w/cedb69ba9896114afc6cc2db/e/2a61b8026924c36f5ef4d058
You should be able to tweak the values in the OnShape model and re-export without an account. The configuration panel is in the top-left of the UI, and the download/export button is in the bottom toolbar.
