Ratchet MrFreeze Pops Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the Mr. Freeze Jumbo Freeze Pops
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 119
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Avoid freezing-cold fingers
Use a Mr. Freeze Jumbo Freeze Pops holder !
Assembly
Slide the "ratchet" into the "handle"
Make sure the "square notch" is facing outwards
Make sure the "ratchet" is properly aligned within the "handle"
Slide the "shaft" into the "handle"
Use the "pusher" to fully push the "ratchet" and the "shaft" into the "handle"
Use a small hammer if necessary
You can discard the "pusher"
Usage
Slide the Mr.Freeze into the "holder" and start eating
When you have about 3 cm (1 inch) of loose Mr.Freeze wrapper, insert the "winder" into the "holder", slide it over the wrapper until the square notches click into place, then start to turn.
Change log
V4 - Improved holder and winder
V3 - Added a ratchet to the winder
V2 - Added a winder
V1 - First release