1 / 2
Air Intake for Honda Fit GD3 07-08 — zdjęcie 1
1 / 2

Air Intake for Honda Fit GD3 07-08

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Air intake for Honda Fit 07-08

Ocena
0 / 5
Polubienia
4
Pobrania
50
Wydruki
0
Wyświetlenia
297
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I wasn't happy with the intake options I had for my GD3 Fit. I drew this and have had it on the car since December of 2025 without issue.

OEM Intake Air Temp sensor grommet and the OEM PCV grommet are used. You only need to make a connection from the PCV grommet to the engine side of the PCV system. It uses a DC Sports air filter DC-RAF275 and 2.5" to 2.75" silicone coupler, I trimmed about 1/4" off each side of the coupler to shorten it as it is a bit too long, both available on Amazon, the hose clamps are OEM I had them laying around any of the correct diameter should work. The sound is good; it puts the air filter in a good spot to pick up outside air.

3D printing settings

Printed in ASA or ABS, Organic supports were used, but it does print with no supports. Place the filter end down on the build plate. 25% infill, the wall thickness on the tube is 6mm so it is very strong. Printed on an Ankermake M5C 220x220x250 build volume. the Fit parts are small it just barley fits in the build volume.

Tagi