1 / 5
Wallie( Remix – Full M3x8 Heat+set Inserts (4.2×3mm) + Cap — zdjęcie 1
1 / 5

Wallie( Remix – Full M3x8 Heat+set Inserts (4.2×3mm) + Cap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the Wallie wallet. All M3 screws Heat-set inserts (OD 4.2 mm × 3 mm), the same M3×8 screws throughout.

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the excellent Wallie - Advanced Lever Action Wallet by SMACKMAX

Changes made:

• M3 heat-set inserts (OD 4.2 mm × 3 mm) used on every screw except the top tension screw

• The top tension screw uses the same M3×8 — push while turning to force it into the plastic and create the thread

• Same M3×8 screws used for the entire wallet

• Added a removable plug that covers the tension screw. The top of the plug sits flush with the plate so it blends with the design/patterns.

Hardware needed:

- x5 M3 heat-set inserts (3 mm long)

- x6 M3×8 screws

Assembly:

1. Install the heat-set inserts in all holes except the top tension screw

2. Assemble the wallet with M3×8 screws

3. For the top tension screw: push while turning to force it into the plastic and create the thread

4. Place the removable plug over the tension screw (it sits flush with the plate)

Thanks to SMACKMAX_ for the original design! 

Ps: Printed in Petg, should work with other filament.. 

it is my first upload, not all perfect, but all fit pretty well in my case, and if it can save some time to other. o/

Tagi