1 / 3
Freestanding Prusament Rolodex Stand – Legacy Cardboard Spool — zdjęcie 1
1 / 3

Freestanding Prusament Rolodex Stand – Legacy Cardboard Spool

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A freestanding, hand-spun Rolodex stand for legacy cardboard-core Prusament spools.

Ocena
0 / 5
Polubienia
3
Pobrania
2
Wydruki
0
Wyświetlenia
42
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Freestanding Prusament Rolodex Stand

Turn an old Prusament spool into a freestanding, hand-spun Rolodex. This triangular A-frame stand holds the spool center approximately 150 mm above the desk and uses a keyed drive puck, square shaft, and six-lobe twist knob to rotate it.

Designed specifically for the older Prusament spool with the cardboard center tube and radial key slot. It is not compatible with the newer RFID spool.

The business-card containers are not included. Download them from Mathieu’s original Prusament Rolodex.

Included parts

  • Left and right triangular frames

  • Two snap-in anti-racking spreaders

  • Solid idler puck

  • Keyed drive puck

  • 12 mm square through-shaft

  • Twist knob

No screws, bearings, or purchased hardware are required.

Printing

PETG is recommended, especially for the snap-fit and rotating parts.

  • 0.20–0.32 mm layer height

  • 4–5 perimeters

  • 20% infill

  • No supports

  • Print the shaft vertically on its round head with an 8 mm brim

Print the frames flat, pucks flange-down, spreaders on their continuous flat face, and the knob flower-face-down.

Assembly

Snap both spreaders completely into the frames. Insert the idler puck into the left side of the spool and align the keyed puck with the spool’s slot on the right. Feed the shaft through the complete assembly, check that the spool rotates freely, and install the knob last.

The knob is intentionally a permanent snap fit. Dry-fit the keyed puck and shaft before installing it.

Co-built with Codex and Sol 5.6.

This stand is a remix for Mathieu’s original model and is shared under the same CC BY-NC-SA 4.0 license.

Tagi