Dually Wheel(Trx4 and SCX10)

I've always had a problem with the cheaply designed dually adapters for 1/10 RC cars, so I've set out to make a better one. I have designed one of these before, it had some issues, which I fixed in this version. This is designed for 1.9 Wheels but if requested, I can make some for a bigger wheel. This is designed for my trx4 so the wheel clearances portal axles on both scx10 iii and trx4 models. I have not tested on any other axles but if needed I can make an adjustment.

Assembly:

Before assembling the wheel itself, make sure to put the bead lock ring into the inside of the tire, there are grooves that you have to line up with the pieces in the next step. Now you can assemble the bead lock wheels using 5 M3x6mm screws. Remember to make sure your tire is facing the right way if it is a directional tire.

On some bead lock wheels, it's possible to take out the center piece that mounts up to the nut. Typically held on by 6 m3 screws. You must remove this piece in order to continue with the build. 

1. Grab the inner wheel and slide it onto the axle, making sure its fully pressed on so you don't strip out the wheel. Tighten on a nut using the tool of your choice. 

2. Next you screw on the outer piece labeled "Dually Outer" using 8 M3x16mm screws (4 is plenty but there is 8 holes just in case)

3. After that, fit up your wheel with the center piece taken out of it. Screw the 6 m3 screws (that you used to take the center piece out) into the top of the "Dually Outer" piece.

Make sure to put the inner tire on BEFORE you put on the outer wheel. 

If there are any questions, I will try my best to respond to comments.