Aerobar Extensions D-Shaped Bridge for Wahoo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fits between 22.2 mm Aerobar extensions to hold accessories that mount to 31.8 mm bars, like a cycle computer.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
This is a simple D-shaped piece that fits between two 22.2 mm extensions bars of an aerobar ("Triathlon-Lenkeraufsatz").
Its upper radius is 31.8 mm to accept common zip-tied accessories and the bottom is flat so it doesn't stick out below the extensions and it's much easier to print without any supports. This also gives the bridge some downwards offset, which ends up placing my Wahoo Roam closer to the extension bars. May not work for accessories that need a fully rounded tube.
The STL file is designed for an extension spacing of about 40 mm between the tubes. Open the aerobridge_parametric.slvs and edit the center dimension in the fourth layer g004-extrude-to-spacing if your extensions have a different distance.
On the photo it's ziptied to Zipp Vuka Clip extensions.