KingSong s18 smaller battery holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The plastic thing that holds the smaller battery (the rear left and rear right batteries) on ks s18 EUC.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 57
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- GNU General Public License v3.0
The model is for the left side — mirror it for the right side.
The model isn't perfect, but good enough. It follows original model curvature very well, including the notch for the suspension pipe. On the photo you can see it installed (on the right), and the older original holder is placed for comparison (on the left).
For filament — I think PETG-CF might fit well (if you have a nozzle that can withstand the abrasiveness, that is). ABS should work too. Myself I first printed it with ABS (1st photo), then re-printed with PETG-CF (last two photos). In my unscientific testing with breaking calibration models it feels like PETG-CF is stronger (15% of CF in my case). Though I guess main upside is PETG* is printable with PEY plates (that's where the colorful look on the photos comes from).
The model was created in FreeCAD and I include the CAD file here (the one with .FCStdextension), in case you'd desire to change/improve the model. My first serious experience with FreeCAD, so don't judge the sources too much 😅 Sketches could've been done in a better way, but it's easy to be wise after the fact…