Dyson DC05 Motorhead Wand Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made of unobtanium now. No recourse but to design my own.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
DC05 Motorhead has two of these clips. One secures handle to wand, the other wand to motorhead at the lower end. The end of the hook breaks off and thus leaves no way of securing these components together. Vacuum is old, but still out there. Clips are unobtainable now as spare parts.
Print from ABS/ASA or a reinforced filament. I printed upside down laying flat on button top to minimise supports. I guess ultimate strength would be if you printed on side so layer lines run along shaft and hook. Use plenty of walls for shaft strength (I used 4) and heavy infill.
It's quite a small part so if you have a smaller nozzle, or reduce the layer height a little to print the center barrel section where it pivots as cleanly as possible.