LRS-600 in Ender 5 Plus screwhole adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A pair of adapter plates to mount an LRS-600 powersupply in an Ender 5 Plus.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A pair of small plates to mount a MeanWell LRS-600 or LRS-600N2 powersupply inside the electronics enclosure of an Ender5 Plus, using the screwholes of the original ChengLiang P500W24V.
Since the screw holes don't line up, and I didn't want to take a drill to the enclosure, I made these plates.
They also mount the LRS powersupply a bit more towards the back. This makes sure that the line voltage switch stays accessible through the original hole in the enclosure.
The plates mount to the powersupply using the original screws. The powersupply with plates then mounts to the enclosure using 4pcs M4x8mm screws.
The screwholes are slightly undersize (3.7mm) so you can force thread them in or use a thread tap to pre-form threads in the holes.
Advise to print out of PETG and print with thick walls (1.6 to 2mm or so) so the screws have enough plastic to bite into.