Adidas Logo

Adidas Iron On Logo

 Print:

 Use the template I’ve already prepared.

 I set the thickness to 0.32 mm because that’s the ideal thickness:

 it holds up well but stays flexible

Place the piece flat on your T-shirt (I recommend using 100% cotton or a cotton blend).

 Protect:

 Cover the entire design with wax paper (baking paper).

 Iron:

 Set the iron to high heat with no steam.

 Apply firm pressure over the transfer for about 10 to 15 seconds.

 Check:

 Let it cool for a moment and make sure the edges are firmly adhered. If any parts aren’t stuck down, carefully go over them again

Extra tip:

 To make sure it stays really secure, turn the T-shirt inside out and iron the inside (always protecting the printed area with the paper)

To make it last longer (Washing and Care):

 Washing:

 Wash at a maximum of 30°C to prevent the print from fading over time.

 Dryer:

 Avoid it at all costs the extra heat will cause the plastic to peel away from the fabric.

 Materials: 

The file is printed in PLA and prints perfectly, but if you want it to be super flexible with a rubbery texture and highly efficient, use TPU.

 About this design:

 The profile is optimized to adhere well without leaving a thick patch. The surface comes out super smooth because I enabled the “ironing” (smoothing) feature. It prints in a couple of minutes and uses very little filament. .3mf 

Specifications: 

Layer height: 0.16 mm Total thickness: 0.32 mm Print bed: Tested on textured PEI