Unofficial Sovol SV08 Indx bed spacers for spring loaded beds

Sovol SV08 – Bed‑Lift Spacer Set for Indx Toolhead Compatibility

If you’re running the Indx system on your Sovol SV08, you’ve probably noticed the toolhead sits higher than the stock configuration — which means the bed needs to be raised for proper reach and safe operation. This spacer set solves that cleanly and reliably.

These custom‑designed spacers lift the SV08 bed 30 mm above the base, providing the clearance required for the Indx toolhead to reach the build plate without interference. The geometry is optimized for strength, printability, and long‑term stability under the constant load of the bed assembly.

Features

• ✔ 30 mm lift to match Indx system requirements

• ✔ Drop‑in fit for the Sovol SV08 bed mounting points

• ✔ Robust stepped design for improved load distribution

• ✔ Centered through‑hole for clean bolt alignment

• ✔ Print‑friendly shape with no supports required

Recommended Print Settings

• Material: ABS/ASA (for heat and compression resistance)

• Infill: 40–60% (Gyroid or Cubic recommended)

• Walls: 4–5 perimeters

• Layer Height: 0.2 mm

• Supports: Not required

Installation

Simply remove the stock bed hardware, place the spacers at each mounting point (higher spacers at the corners and lower spacers in the middle), and reassemble using your existing corner bolts and 10mm longer replacements bolts for the middle spacers. Once installed, the bed sits at the correct height for Indx toolhead operation with no wobble or flex.

Why This Exists

The Indx system is fantastic — but the SV08’s stock bed height doesn’t play nicely with its toolhead geometry. These spacers provide a clean, printable, and reliable fix without modifying the printer frame or sacrificing rigidity.