Dapper Rabbit

These parameters are for an outdoor statue using iSANMATE ASA Filament 1.75mm Marble.

INFILL: Because this guy is going to be outside, I set my infill at 50% Tri-hexagon. 

Print Settings

• Layer Height: 0.16 mm

• Initial Layer Height: 0.20 mm

• Line Width: 0.42 mm (for a 0.4 mm nozzle)

Walls & Shell

• Wall Count: 3

• Wall Line Width: 0.42 mm

• Top Layers: 5

Material (ASA)

• Nozzle Temp: 255–260°C

• Bed Temp: 100–105°C

• Chamber Temp: If available, 45–55°C

• Fan Speed: 0% (ASA hates cooling — only use 10–15% for tiny overhangs)

Speed

• Print Speed: 40–50 mm/s

• Outer Wall Speed: 25 mm/s

• Inner Wall Speed: 35–40 mm/s

• Initial Layer Speed: 20 mm/s

Supports

For your rabbit statue (upright, coattails, arms holding tails):

• Support Style: Tree

• Support Density: 15%

• Support Overhang Angle: 45°

• Support Z‑Distance: 0.14 mm (initial z-distance was .18 and my print failed at his coattails)

Build Plate Adhesion

• Brim: 8–12 mm ASA warps — (I did not use a brim and I didn't have any problems)

My model is 12", so I had to slice it, but the files are for a 4" model.