Triple XT60 Distribution Socket for Bass Shakers

Triple XT60 Distribution Socket for Bass Shakers

About the Project

This compact distribution socket was designed for a chair-mounted bass shaker system.

It provides three XT60 outputs from a single enclosure and was originally made to connect up to three bass shakers installed on a gaming chair.

At the moment, my own setup uses only two outputs, but the third port was included from the start for future expansion.

Design

The enclosure was made specifically for the available mounting space on the chair and is secured with screws.

The XT60 connectors sit tightly in their slots with minimal movement, and the housing keeps the wiring organized instead of leaving multiple loose connectors hanging under the seat.

A flexible TPU cable strain relief can be added later where the cable exits the enclosure.

Printing

Recommended materials:

• PETG

• ASA

• ABS

• PA or PA-CF for a tougher version

TPU can be used separately for the cable strain relief.

Print orientation and supports may depend on your own printer and connector tolerances.

Before final assembly, test-fit the XT60 connectors and screws. Minor sanding or hole adjustment may be required.

Notes

This model was originally designed only for my own chair, so it includes my personal logo on the front.

I decided to share the model with the community, but honestly, I was too lazy to rebuild the part just to remove the logo. 😀

Consider it a small GARAGE CUSTOM signature.

Safety

This is only a passive connector enclosure. Make sure the wiring, cable gauge, polarity, amplifier output, and total current are appropriate for your own bass shaker system.

Double-check polarity before connecting any equipment.

Show Your Build

If you print one, upload a make. I would be curious to see what kind of vibrating furniture this thing ends up powering. 🔌🪑