Sam's Club Solar Path Light Low-Voltage Conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sam's Club Solar Path Light Low-Voltage Conversion - 3D-Printed Mounts + Guide
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Convert the lantern-style Sam's Club solar path light shown into a wired Class 2 low-voltage landscape fixture. This project reuses the original top, glass shade, decorative shield, and post, then adds a 3D-printed inner socket plate and either a modified factory post-side mount or the included 3D-printed replacement. A fully illustrated seven-page PDF guide is included.
Overview
This project converts the lantern-style Sam's Club solar path light shown in the photos from its original solar electronics to a wired low-voltage landscape-lighting fixture.
The conversion keeps the original:
top/cap
glass shade
decorative shield
center tube/post
It adds a black rubber T10/194 wedge socket, a 3D-printed inner socket-mount plate, and one post-side mount.
There are two post-side mount paths:
Modify the original factory mount using the cutting and drilling steps in the PDF.
Print the replacement post-side mount and skip the factory-mount modification.
Use only one post-side mount. Do not stack the modified factory mount and printed replacement together. The separate 3D-printed inner socket plate is used with either option.
Compatibility
This was designed for the exact lantern-style fixture shown in the photos. Before printing, cutting, or drilling, compare your light carefully with the reference images. Confirm that the glass has the same center wire opening, two molded screw divots, decorative shield, and center-tube arrangement. Production revisions may differ.
Suggested print settings
These are practical starting settings for a functional outdoor part; use your tested settings if they differ.
Material: PETG, ASA, or another outdoor-suitable filament
Layer height: 0.20 mm
Perimeters/walls: 4
Top and bottom layers: 5
Infill: 30-40%
Non-printed parts and hardware
donor solar light matching the lantern style shown
black rubber T10/194 wedge socket with red and black pigtail leads
compatible low-voltage T10/194 lamp
compatible Class 2 low-voltage landscape transformer
two 6-32 x 3/4 in machine screws with matching nuts
outdoor/wet-location low-voltage wire connectors
3/16 in spear-point glass/tile bit
small pilot bit plus 9/64 in, 3/8 in, and 15/64 in bits if modifying the factory mount
Example black rubber socket source - verify the dimensions before ordering: