Fireball Tool 6" Fence Block Gridfinity Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Gridfinity holder for the 1"x2"x6" fence blocks from Fireball Tool.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 9
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a basic Gridfinity tray to hold the 1"x2"x6" fence block from the Fireball Tool 3/4" fixturing system, part number FA75-SBS620-BDK. At 1x4 squares, it does take up some drawer space, but this block isn't going to fit vertically in many drawers. If you do have a somewhat deeper than normal drawer, you could always stack a second block on top of the first one to maximize use of the space..
Like my other Gridfinity models, the base is altered to accept 6x3 magnets as a press fit, with the upper surface of the magnet holes modified to make the slicer bridge across correctly for a clean result. Due to the size of this model, I have included sacrificial “mouse ears” in the CAD to give the ends more surface area to help prevent them warping off the bed. These will need to be removed after printing.
The unit pictured was printed out of Overture PLA on my Bear upgraded Mk3S+, using a 0.6mm nozzle, at 0.3mm layer height.
Edited to add; these should also fit any of the other 1x6 Fireball blocks; including twist block FA75-MBH641-S-BDK, twist block FA75-MBH644-S-BDK, and stepped fence block FA75-MBH612-A1-BDK.