1 / 6
Yoopai Filament Dry Box Desiccant Holder — zdjęcie 1
1 / 6

Yoopai Filament Dry Box Desiccant Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Desiccant box that slides into the rear of the Yoopai dry box. Holds about 70 g desiccant depending on silica bead size

Ocena
4,5 / 5
Polubienia
11
Pobrania
139
Wydruki
3
Wyświetlenia
506
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

This is a custom desiccant bin for the Yoopai filament storage box. The design uses a hexagonal mesh to maximize airflow and desiccant surface area while keeping the structure rigid.

I printed mine in PLA, since the bin itself isn't exposed to heat. If you plan to dry desiccant in place (without removing it from the bin), print in ABS or ASA instead.

Are the Yoopai boxes any good? Time will tell, but early results are promising — over one week I logged 4.3–5.8% RH using just two 20g desiccant packets with a half-reel of dry ASA inside. Data logger results attached; I'll update as more data comes in. Box purchased via Amazon.  Data logger used is Uni-Trend model UT330TH with stated accuracy of 2.5% RH

Bin — Built for durability, so there's more plastic left in than a minimal design. Feet lift the bin off the base of the Yoopai box, and holes run through all surfaces, both to help dry air near the desiccant equalize with the more humid air elsewhere in the box. Holds ~70g of desiccant depending on silica gel bead size.

Lid — Snug enough to stay seated, but not so tight that desiccant scatters when you open it.

Printing — Printed solid, no special settings required.

Future Development  I am waiting on some Activated Alumina to arrive.  I ordered 2 to 4mm bead size so I will probably increase the hole size to improve the moist / dry air diffusion

Other Related Models

Check my profile for upcoming projects and follow to be notified when new models drop

Found this useful? These bins were developed through quite a few test iterations in different materials. If you want to contribute to the next round of testing for the next project, it’s always appreciated: buymeacoffee.com/ChrisNZL.

Tagi