CH160 Plus SFX PSU backwards mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An alternate mounting bracket for SFX power supplies on the Deepcool CH160 Plus computer case.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 122
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
Description
This bracket allows you to top mount an SFX PSU and have its connector side facing towards the motherboard side of the case, which make for a cleaner cabling path.
Restrictions and caveats
You can only use a 120mm front fan if you use this bracket.
I'm publishing this after some requests from PCPartPicker users; it was built for my own use and uses hardware that I had on-hand. The design is not optimized in any way,.
I've included the OpenSCAD file for remixes.
Additional Hardware
4x M3x10mm joiners (female-female standoffs). I used the “uxcell M3 x 0.5-Pitch 10mm Length 304 Stainless Steel Metric Hex Coupling Nut, 10-Pack” from Amazon.
2x UNC6-32 bolts to mount the PSU to the brackets. (I think they were 3/8", but you can modify the openSCAD pockets for whatever you are using.
4x M3 bolts. I don't remember the length I used, but they're used to attach the bracket to the case through the M3x10mm joiners above, so something like M3x16 through M3x20 should work.
4x M3 fender washers (optional, recommended)
Installation
Print in a relatively heat-resistant material
Print with the L shape flat on the plate
Supports are necessary for the clearance hole in the corner.
Insert M3 joiners in the holes
Remove the existing bracket from the case if you had it installed
Align the M3 hole with the case holes on top and front.
Attach with M3 bolts.
Attach PSU with UNC bolts