1 / 3
Cinnamoroll-Inspired Jewelry Drawer Organizer — zdjęcie 1
1 / 3

Cinnamoroll-Inspired Jewelry Drawer Organizer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cinnamoroll Mini Drawer for jewelry

Ocena
0 / 5
Polubienia
8
Pobrania
19
Wydruki
0
Wyświetlenia
134
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

# Cinnamoroll-Inspired Jewelry Drawer Organizer

A chunky desktop organizer shaped like everyone's favourite floppy-eared cloud puppy —

with five drawers hidden inside. The eyes are the drawer pulls, and each ear is its own

deep drawer.

## Features

- 5 drawers — two upper face compartments, one wide lower drawer, and one in each ear

- The eyes are the knobs. No hardware, no magnets, nothing to buy

- Face details are recessed 2 mm (mouth + blush), so they're easy to paint cleanly

or colour-swap with a filament change

- No supports required in any of the print orientations below

- Sized to fill a 250 × 210 bed (Prusa MK3S and similar)

## Dimensions

230 × 131 × 70 mm assembled · roughly 640 g of filament total

## Parts (11 STLs)

| File | Notes |

|---|---|

| CinnamorollShell | The body — 3 mm walls, internal dividers |

| Drawer1_upperLeft / Drawer2_upperRight | Face drawers, ~55 × 69 mm fronts |

| Drawer3_lower | Wide drawer — carries the mouth and blush |

| Drawer4_earLeft / Drawer5_earRight | Tall curved ear drawers, the roomiest of the five |

| Knob_eyeL / Knob_eyeR | Oval eye pulls — print these in blue |

| Knob_chin / Knob_earL / Knob_earR | Round pulls |

## Print settings

- 0.2 mm layers, 3 perimeters, 15–20% infill

- PLA or PETG both work

- No supports

## Orientation (important)

- Shell — exactly as exported: flat back on the bed, opening facing up

- Drawers — rotate so the open top faces up, the way they sit in use.

Do not lay them front-panel-down; the tray's back wall would then have to bridge

the whole opening

- Knobs — front face down, peg pointing up. Gives the smooth bed finish on the

visible side

- The ear drawers have a tall thin front panel — add a brim

## Assembly

Glue the five knobs into their 5.4 mm holes and you're done. Eyes on the two upper

drawers, round pulls on the lower drawer and both ears.

## Tolerances

Drawers have 0.4 mm clearance on all sliding faces. If your printer runs tight,

scale the drawers to 99.5% or give the sides a quick sand.

## Painting

The mouth and blush are recessed wells, so you can flood them with acrylic and wipe

the surface flat — the engraving edge does the masking for you.

Tagi