1 / 7
FilaDock – Modular Filament Hub for INDX & IKEA SKÅDIS — zdjęcie 1
1 / 7

FilaDock – Modular Filament Hub for INDX & IKEA SKÅDIS

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

INDX filament management system with SKÅDIS mounts, 8 spool capacity, sensor integration and Bowden routing.

Ocena
0 / 5
Polubienia
41
Pobrania
18
Wydruki
0
Wyświetlenia
1209
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

FilaDock is a modular filament management system designed specifically for the INDX and built around the IKEA SKÅDIS medium pegboard.

The goal of this project was simple: create a clean, organized and practical way to store filament while keeping the complete filament path—including the original INDX filament sensors—mounted to a single pegboard. The result is a compact and tidy setup where the spools, sensors and Bowden tube routing all come together in one organized system.

The medium SKÅDIS pegboard perfectly accommodates 8 filament spools, with 4 mounted on each side, while leaving enough room for the sensor mounts and Bowden tube routing.


FilaDock was designed to keep the INDX filament setup clean, organized and easy to use. By combining spool storage, sensor mounting and Bowden tube routing into one system, it creates a compact and practical solution for anyone using an IKEA SKÅDIS pegboard as part of their workspace.

The design is fully modular, allowing future adjustments or expansions depending on your setup.


Features

  • Holds 8 filament spools (4 on each side)

  • Designed for the IKEA SKÅDIS medium pegboard

  • Dedicated mounts for the original INDX filament sensors

  • Clean Bowden tube management

  • Modular design that is easy to expand or modify

  • Snap-fit spool holder design without the need for additional screws or hardware

Printing
All parts were printed in PETG using the 0.20 mm Structural profile.

The complete system uses approximately 900 grams of filament.

Most parts print without supports. Enable automatic support generation in your slicer, as a few small supports are required for the SKÅDIS hooks. These are minimal and remove easily after printing.

Additional hardware
Besides the printed parts, you'll need:

  • 8× M10 Bowden adapters (one for each spool holder)

  • Approximately 5m PTFE bowden tube

The original INDX filament sensors also require a Bowden adapter. You can use this model:

INDX Filament Sensor Bowden Adapter (ECAS04 / PC4-M10)

Tagi