Hush-98 Jedi Comlink - Star Wars

Update: I originally posted this model on Thingiverse a while ago, and had updated and added mods for it there but not here. I will eventually move them over to this site, but for now if you want the most current version you can still find it there: https://www.thingiverse.com/thing:3531129

Here is my take on the Jedi Comlink, model Hush-98. Just eyeballed it using visual dictionary photos, so scale and dimensions may not be accurate but it looks close.

Bent tab on back is literally just bent and glued down at the angle. Rear square panel is just glued to the back.

Also included a display stand.

There's a third "tridial" needed for the rear, just forgot to include it in the diagram picture. It may need to be scaled down a bit to fit the hole.

Enjoy!

Print instructions

All parts should already be oriented to print.

Use supports for microphone and rear round. Support for the body depends on layer height and overhang ability. Check your slicer preview to see if support is needed.

The body in the photos was printed at resolution of .05 mm, which is overkill but looks nice with all the curves. Made with silver Prusament.

Approximate print times:
.05 mm = 7 hours
.2 mm = 2 hours