1 / 13
Kamen Rider Geats: Buckle Stands — zdjęcie 1
1 / 13

Kamen Rider Geats: Buckle Stands

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two Styles of stands for holding Kamen Rider Geats Buckles

Ocena
0 / 5
Polubienia
5
Pobrania
52
Wydruki
0
Wyświetlenia
163
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

Both these stands were made for the purpose of completing my Geats Shelf and I felt these were worth sharing.

These stands allow the Buckles to be slid on identically to the Desire Driver and are equally easy to remove for when you want to use them, both of the Holders have overhangs on the track where they grab the rail of the buckle and were necessary to be compatible, the best way I found to print these overhangs was by using a separate support material that doesn't adhere to your filament, while you can use something fancy I found PLA with PETG Support interfaces (Seen in image 4) to be fantastic for this purpose and would separate even with no gap between Support and Overhang.

These holders also don't activate buckles that have their own Standby sound like Fever, Geats XI or Bujin Sword as they have an open slot where the buckles would normally press into the Driver, triggering the sound. This was tested with; Fever, Powered Builder, Twin Command, Laser Raise Riser, Geats XI and Bujin Sword. While extremely unlikely it may still trigger the sound of other buckles if their button to activate the standby (under the rail) is shaped weirdly.