Drained tray for circular Dish and hand soap pumps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A self draining 2-part tray for circular Soap pumps. An upper perforated part and a bottom sloped part with a drain.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
We have a dish soap pump and a soap pump by the sink on our kitchen counter. They are often used with wet hands, causing drops of water running down the canister and assembling around its base. Causing in its turn dirt and particles to collect around it. Not a big problem, but we like to keep it nice and tidy.
I made a tray which is sloped against an open drain in the low end, making it self-draining against the kitchen sink. And an upper perforated tray to put the canister on that lets the water droplets to run down to the sloped tray below.
The soap pump canister we have are 83 mm in diameter. So if your soap pumps have a different diameter you need to scale the print up or down based on this diameter.
I printed the bottom tray in White TPU to get a bit more friction against the kitchen counter. But getting the supports off from a TPU object is a bit of a pain I discovered. I tried both linear and tree like supports, both with a brim. I think the Tree like supports was easiest to remove. But the linear supports gave a better and more even bottom surface. In both cases I had to use pliers, a sharp mat knife, file and my grinding mouse to remove the supports. So for the best print result I would recommend linear supports.
In my slicer software I rotated the tray about 2,5 degrees “backwards”, to get a completely flat/horizontal upper surface without any joint lines from print head direction changes. And also to reduce the amount of supports as much as possible.
The upper tray I printed in White PLA Tough+, in up-side-down position so no supports were needed. The upper tray has a small arrow in one side which shows where the low end is, and should be pointed towards the drain.