Q2 Box Shelf - fits on QIDI Box Riser provided by QIDI
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 'riser' on top of the QIDI Box factory riser (provided with the Box) to create a space for the glass to slide
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 70
- Wydruki
- 1
- Wyświetlenia
- 559
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a shelf using 350mm 2020 aluminum extrusions (2) as the bridge between the parts. I used M4x8 screws and appropriate 't-nuts' from a set that you could use M3 or M5 with also. I got the extrusions on Amazon (about $13 US for 4) as well as the t-nuts (about $6 for the set).
Each side took 160g of filament - did it in PETG, because the temp in the Box with the lid open (for PLA and PETG) only gets to 30C and the glass is closed for stronger filaments and the ambient air temp since this is outside the enclosure is actually less then. Purists would say you should do this in ASA or ABS (I'd use ASA if so).
On the X-Max 3 it took about 5 1/2 hours for each piece (0.4mm nozzle). I used 4 walls and 15% gyroid infill, the rest stock profile. I printed these with the 'lip' up and organic supports under the two slots for the extrusions. There's an extra 2 mm in the slot so if the surface is rough after support removal it's no issue to worry about or need to get them perfectly smooth. Print as depcited, which is upside down from how they'll be used.