Just-A-Rizer XL LED Riser for the Snapmaker U1 - **Updated**

The Just-A-Rizer XL is an upgraded, feature-packed LED riser engineered specifically for the Snapmaker U1. Building upon the original design, this expanded version adds crucial extra headroom, encloses the rear frame, and introduces accessory mounting options along the exterior.

Key Features & Upgrades

• Increased Height & Enclosed Rear: Provides generous clearance for PTFE tubes and wiring bundles while fully closing off the back section to improve heat retention and draft protection.

• Integrated LED Channel: Features a built-in recessed track to seat internal LED strip lighting around the full top perimeter for maximum chamber visibility.

• Multiconnect Compatibility: Equipped with side-mounting points compatible with the Multiconnect ecosystem to mount tool holders, scraper mounts, and maintenance bottle racks directly to the printer frame.

• BIQU PopCap & Top Cover Support: Replicates the native top lip profile of the standard Snapmaker U1 frame, ensuring seamless fitment with the BIQU PopCap as well as other aftermarket top covers. However, if using the Snapmaker top, the cord junction box will need to be relocated, or an extension cable will be needed.

  

Version 2 Updates

• Added a cord relief to accomodate the BIQU PandBreath

• Added provision for the official SnapMaker Top Cover

• Various quality improvements

Recommended Print Settings

• Material: PETG, ABS, or ASA (recommended for higher heat resistance, though PLA works for ambient printing).

• Walls/Perimeters: 3–4 wall loops for structural rigidity.

• Infill: 15–20% (I use Adaptive Cubic).

• Supports: Minimal supports required depending on your bridge settings around the corner joints and mounting slots.

LED Strip shown: https://a.co/d/093SD4GO

See my Just-A-Lube and Glue Holder!