Dapper Mouse

This little guy was printed for my garden to go along with my other statues. He was printed using a 4.0mm nozzle.

• These parameters are for an outdoor statue using iSANMATE ASA Filament 1.75mm Marble using a 4.0mm nozzle.

• INFILL: Because this guy is going to be outside, I set my infill at 50% Tri-hexagon. 

  Print Settings

  • Layer Height: 0.16 mm

  • Initial Layer Height: 0.20 mm

  • Line Width: 0.42 mm (for a 0.4 mm nozzle)

  Walls & Shell

  • Wall Count: 3

  • Wall Line Width: 0.42 mm

  • Top Layers: 5

  Material (ASA)

  • Nozzle Temp: 255–260°C

  • Bed Temp: 100–105°C

  • Chamber Temp: If available, 45–55°C

  • Fan Speed: 0% (ASA hates cooling — only use 10–15% for tiny overhangs)

  Speed

  • Print Speed: 40–50 mm/s

  • Outer Wall Speed: 100 mm/s

  • Inner Wall Speed: 150 mm/s

  • Initial Layer Speed: 20 mm/s

  Supports

  • Support Style: Tree

  • Support Density: 15% - 30%

  • Support Overhang Angle: 45°

  • Support Z‑Distance: 0.18mm

  Build Plate Adhesion

  • Brim: 8–12 mm ASA warps — (I did not use a brim and I didn't have any problems)If your slicer doesn't automatically add supports under his chin you will probably want to paint them on. If you zoom in on my printed model, you will see where they weren't added. 

Hope you like this little garden addition as much as I do.